Download center
Welcome to the download center!
Here you can find
- the quick guide for first installation
- standards
- conditions of warrant and liability.
quick guide pdf
Low Voltage Directive (LVD) 2015/35/EU
EU declaration of conformity (Doc)
Low Voltage Directive (LVD) 2015/35/EU
EMC Directive 2014/30/EU
RoHS Directive 2011/65/EU
ARN 4105
Unit Certificate Based on VDE-AR-N 4105:2018-11
Certificate of NS protection Based on VDE-AR-N 4105:2018-11
EN50549-1
SOP 9-1_15 GCC Certification Program, 09/21
Based on EN 50549-1:2019
IEC 62116
IEC 62116:2014
TOR Erzeuger (Austria)
SOP-9-1_15 GCC Certification Program, 09/21
Based on TOR Erzeuger Typ A Version 1.1
C10/11 (Belgium)
SOP-9-1_15 GCC Certification Program, 09/21
Based on C10/11 édition 2.2, 15 Mars 2021
Quality and Warranty
During the production and assembly of the next3, each unit undergoes several checks and tests which strictly comply with established procedures and device safety requirements. The manufacturing, assembling, and testing of each next3 are entirely carried out in our factory in Sion (CH). The warranty for this equipment depends upon the strict application of the instructions in this manual.
The next3 inverter has a ten (10) years warranty (starting from the date of purchase) against material and manufacturing defaults. The defective product will be either repaired or replaced at the discretion of Studer Innotec. A warranty extension up to 15 years is possible with the Studer Care program, giving also other advantages.
Exclusion of warranty
No warranty claims will be accepted for damages resulting from handling, use or treatment that are not explicitly mentioned in this manual. Damages arising from the following causes are excluded from the warranty:
- Voltage higher than 900V across PV terminals.
- Voltage higher than 70V across battery terminals.
- Accidental presence of liquids in the equipment or oxidation due to condensation.
- Damage resulting from falls or mechanical shocks.
- Modifications carried out without the explicit authorisation of Studer Innotec.
- Nuts or screws that have been too much or not enough tightened during the
installation or maintenance. - Damage due to atmospheric surge voltage (lightning).
- Damage due to inappropriate transportation or packaging.
- Damages due to improper installation
- Disappearance of original identification marks.
Never take off or damage the rating plate showing the serial number. It enables to check and follow-up the data specific to each equipment and is vital for any warranty claim.
Exclusion of liability
The installation, commissioning, use, maintenance, and servicing of the next3 cannot be subject of monitoring by Studer Innotec. Therefore, we disclaim all responsibility and liability for damage, costs or losses resulting from an installation that does not comply with the instructions, a faulty operation or inadequate maintenance. The use of Studer Innotec equipment is in any case under the responsibility of the customer.
This equipment is neither designed nor guaranteed to supply installations used for vital medical care nor any other critical installation entailing potential risks of important damage to people or to the environment.
We assume no responsibility for the infringement of patent rights or other third parties’ rights resulting from the use of the inverter.
Studer Innotec reserves the right to make any modifications to the product without prior notification.
Studer Innotec is not liable for incidental, direct or indirect damages of any kind, including any profit loss, revenue loss or damages caused to equipment or goods due to defective equipment.